Garden JET Pumps

The Garden JET Pumps between the jaw and the outlet flange of the water pump should be tightened according to the torque specified by the manufacturer, and the connection must be firm. Inspection method: check with a spirit level.锘?016-01-15 Installation and commissioning plan of submersible pump 1. Inspection method: lightly hit with a small hammer and observe and check 4.1. 4. 2. Jog check whether the running direction of the water pump is correct,

whether it is consistent with the direction marked on the pump body, and it can be operated with load only after it is correct. Water pump installation 4. 1. Check whether the specifications and performance of the equipment meet the requirements of the drawings, and whether the instructions, certificates and test reports are complete. Inspection method: observe and inspect during hoisting. The insulation resistance of the cable shall not be less than 5;. 4.7.2.

The pump should run smoothly without abnormal sound. Inspection method: check with feeler gauge during installation, and make a record, and check the record during acceptance.4. 4. Water should not penetrate into the motor, and the humidity monitoring device should not operate.3. B. F. 4. Inspection method: disassemble and pull up the water pump, then put it down and install it.

The allowable deviation between the center of the outlet of the water pump and the center of the lower flange of the elbow shall not exceed 5mm. Inspection method: observe and inspect. 4. 3. E.1.5. Check the installation quality records, all technical indicators should be complete and meet the requirements. The number of pieces in each group should not exceed 3 pieces.3

Megosztás a facebookon